Induction Loop Amplifier for T Mode Hearing Aids
Loop amplifier system for fitting a counter to users with hearing aids. The loop amplifier provides a signal to be received by hearing aids with tele-coil (T-coil) function. It provides the hearing aid user with a clear signal, without background noise.
Improves communication by conveying the message clearly. Reducing the effort to communicate.
Ideal for noisy places where the audio amplification of hearing instruments does not provide good results due to background noise. However, with the tele-coil function a noise-free signal is obtained.
Easy installation and low maintenance.
The amplifier can cover a larger area by adapting the loop dimensions, up to approx. 20 m².
Perfect for use at ticket counters, banks, cash registers, checkpoints, motorway access points, car parks, etc.
- Complete kit for installation on counter and or teller window
- Tele-coil hearing aid loop amplifier
- 5 W RMS, THD 2.5%
- 35 – 20k Hz, -10 dBA
- THD+N < 0.2%, 1 kHz, 1W
- 1 AUX, 3.5 mm TRS jack, 250 mV
- 1 clip-on microphone, 3.5 mm TS jack, 1.5 mV, Phantom 5 V 1 mA
- 1 Loop, Euroblock
- Current: 2 A
- For loop extension use recommended cable 0.22 - 1.5 mm², maximum length 70 m, impedance 0.5 - 3 Ohm
- Loop for counter 1.2 m² included
- 1.2 m² counter loop
- Countertop or under-counter installation
- Extendable up to 20 m² (using a 4.5 x 4.5 m loop in 4 loops)
- LED operation indicators
- Overheating and overloading
- Microphone and AUX volume
- Output volume
- On/off
- 12 V DC, 1 A with adapter included
- Power consumption: 10 W
- Standby power consumption: 0.5 W
- Amplifier: 155 x 35 x 75 mm depth
- 70 x 70 cm loop cable (1.2 m² coverage) with 1.8 m extension cable
- Clip-on microphone cable: 1.40 m
- 0.3 kg
- Adhesive T
- Loop cable
- Unidirectional clip-on microphone
- CE marked
- For compliance with EN IEC 60118-4:2015-A1:2018 (Electroacoustics. Hearing aids. Part 4: Induction loop systems for hearing aids - System performance requirements)